System Installation

Personnel

One technician

One technician

Refer to Safety Instructions before performing any operation on the RMI System.

Refer to Safety Instructions before performing any operation on the RMI System.

Remove the crate's top and side covers.
Remove the protective film from the RMI System.
Using a cutter, remove five cable ties securing the corrugated tube.
Using a Phillips screwdriver, remove the four screws, washers, and clamps securing the main unit to the crate.
Using a Phillips screwdriver, remove four screws, washers, and clamps securing the control unit to the crate.
WARNING
Lifting the RMI units requires four people.
Failure to comply may result in a serious injury.
Lift the main unit and control unit from the pallet and position at the designated installation location.

Remove the crate's top and side covers.
Remove the protective film from the RMI System.
Using a cutter, remove five cable ties securing the corrugated tube.
Using a Phillips screwdriver, remove the four screws, washers, and clamps securing the main unit to the crate.
Using a Phillips screwdriver, remove four screws, washers, and clamps securing the control unit to the crate.
WARNING
Lifting the RMI units requires four people.
Failure to comply may result in a serious injury.
Lift the main unit and control unit from the pallet and position at the designated installation location.

Remove the LED tower light from its packaging.
Connect the LED tower harness to the control unit.
Insert the LED tower to the LED tower mount.
If the hopper was packaged separately, remove it from its packaging.
Using a 4mm Allen key, install four screws securing the hopper to the main unit.
Using a key, open the control unit's front door.
Remove the moisture absorbing bag from the control unit.

Remove the LED tower light from its packaging.
Connect the LED tower harness to the control unit.
Insert the LED tower to the LED tower mount.
If the hopper was packaged separately, remove it from its packaging.
Using a 4mm Allen key, install four screws securing the hopper to the main unit.
Using a key, open the control unit's front door.
Remove the moisture absorbing bag from the control unit.

Open the transparent camera door on the front side of the system.
Remove the lens covers from all cameras.
Open the transparent camera door on the back side of the system.
Remove the lens covers from all cameras.
WARNING
Only a certified electrician should connect the control unit.
Failure to comply may result in injury or damage to equipment.
Connect the control unit to mains power.
NOTICE
A 100kVA UPS can be installed inside the control unit.
Connect the control unit to a UPS.
Connect the control unit's Ethernet cable to an RJ-45 terminal.
NOTICE
If required, run a digital I/O cable through the corrugated tube to the electric enclosure on the control stand.
Remove the air tube from behind the touchscreen's door.
Connect air supply to the air treatment port on the main unit.
Power on the system.

Open the transparent camera door on the front side of the system.
Remove the lens covers from all cameras.
Open the transparent camera door on the back side of the system.
Remove the lens covers from all cameras.
WARNING
Only a certified electrician should connect the control unit.
Failure to comply may result in injury or damage to equipment.
Connect the control unit to mains power.
NOTICE
A 100kVA UPS can be installed inside the control unit.
Connect the control unit to a UPS.
Connect the control unit's Ethernet cable to an RJ-45 terminal.
NOTICE
If required, run a digital I/O cable through the corrugated tube to the electric enclosure on the control stand.
Remove the air tube from behind the touchscreen's door.
Connect air supply to the air treatment port on the main unit.
Power on the system.